|
In-Duct
Page | FAQ | Installation
In-Duct
Air Purifier Installation Guide
Biozone In-Duct
Air Purification units are fairly easy to install. We do recommend that you have an HVAC
professional do the installation. However, if
you are comfortable doing intermediate
electrical wiring, you can install them yourself
in less than an hour. Otherwise, an HVAC
professional will usually do the job for a small
fee. We are happy to answer any questions you or
your installer have while installing the unit.
Just give Biozone Tech Services a call toll free, Monday
through Friday, 9 AM - 5 PM:800-827-8228
The units
arrive with a standard electric plug attached.
This is so that you can plug the unit in to
verify that it is working properly before you
install it. (Some people plug the unit into a
standard wall plug located near their ductwork
and air handler and never actually hard-wire the
unit - this is perfectly acceptable).
SAFETY
NOTICE: DO NOT LOOK DIRECTLY INTO THE UV LAMP.
The unit
should be installed near the supply plenum or
a-coil of your HVAC system. All that's required
is to drill a hole approximately 1 3/4" in
diameter in the main air return duct so that the
lamp on the Biozone Air Purifier will be
centered in the air flow (as much as possible)
and so that the lamp is in a horizontal
position. Insert the lamp into the hole so that
the lamp socket flange is protruding through the
hole and the housing is abutting the duct. Then
attach the transformer unit to the duct through
the mounting arms with the included sheet metal
screws, or use duct tape to hold the unit in
place.
WIRING
Ideally, you
should wire the unit in such a way that it is
always "on" and, even more ideally,
you should wire the circulating fan of your HVAC
system so that it is running constantly as well.
This actually reduces wear and tear on your fan
unit and ensures that your central air
purification system is always doing its job.
A complete
wiring schematic and block diagram for a 24VAC
Fan Circuit is included with each unit.
|
